Motorola L402C - DECT 6.0 Corded/Cordless Phone Guide de l'utilisateur Page 34

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 50
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 33
34 Using the phone
4. When the other handset answers the intercom call,
press MENU on the calling handset to set up the
conference call.
5. Press /BACK on any handset to end a three-
party conference call and leave the other handset
engaged with the caller.
NOTE
During an external call on the corded base, pressing
/FLASH or /SPEAKER on any cordless handset
will join in the call and set up a conference call.
4.15 Setting the dial mode
The default dialing mode is suitable for your country and
network operator. It is unlikely that you should need to
change this setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to
select
SETUP BS
.
2. Press MENU to select
DIAL MODE
.
3. Press MENU and then VOL+ or REDIAL/VOL- to
select
TONE
or
PULSE
.
4. Press MENU to save.
NOTE
If the pulse mode is selected, press */TONE to switch
from pulse to tone dialing temporarily when dialing out.
After the call is ended, the dial mode will change back
to pulse.
4.16 Setting the flash time
The default flash time is 600MS. It is unlikely that you should
need to change this setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to
select
SETUP BS
.
2. Press MENU and then VOL+ or REDIAL/VOL- to
select
FLASH TIME
.
3. Press MENU and then VOL+ or REDIAL/VOL- to
the flash time you want. (8 options are available :
90
,
100
,
110
,
250
,
300
,
400
,
600
and
700MS
)
4. Press MENU to save.
4.17 Setting the area code
1. Press MENU and then VOL+ or REDIAL/VOL- to
select
SETUP BS
.
2. Press MENU and then VOL+ or REDIAL/VOL- to
select
AREA CODE
.
3. Press MENU and then enter the area code.
4. Press MENU to save.
Vue de la page 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 49 50

Commentaires sur ces manuels

Pas de commentaire