Motorola CLEARTONE CM5000 Guide de l'utilisateur télécharger pdf (Page 18)

English

Getting Started

Powering On/Off

To power On, press and hold the rotary knob. The CM5000

performs a self-check and registration routine. After

successful registration, the CM5000 is in service.

To power

Off, press and hold the rotary knob push button.

You hear a beep and the Powering Off message is

displayed.

Powering On with Emergency Button

Press and hold the Emergency button to power On. The

CM5000 powers On in Emergency Mode or in standard

mode (as programmed).

Powering On with Transmit Inhibit Active

Transmit Inhibit (TXI) is a feature allowing you to switch off

transmission before entering a Radio-Frequency (RF)

sensitive area. To activate this feature, press the Menu

button and select More...> Networks > TXI Mode >

Activate.

The TXI Mode remains active at power On. You are

prompted whether to leave the TXI Mode On or not.

Press the Yes soft key to deactivate the TXI Mode. If the

CM5000 was previously used in Trunked Mode, it will register

to the network. If the CM5000 was previously used in Direct

Mode, it will remain in Direct Mode.

Press No in Trunked Mode and the CM5000 powers down.

Warning:

Pressing the Emergency button, even if Transmit Inhibit is activated,

causes the CM5000 to transmit immediately. The CM5000 must NOT

be within the RF sensitive area when entering Emergency Mode.

Warning:

Ensure you have left the RF sensitive area before deactivating Transmit

Inhibit.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Pas de commentaire

Motorola CLEARTONE CM5000 Guide de l'utilisateur Page 18