Motorola CLEARTONE CM5000 Guide de l'utilisateur Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 102
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
7
Getting Started
The CM5000 will power On in Emergency Operation or in
standard mode (as programmed).
Powering On with Transmit Inhibit Active
Transmit Inhibit (TXI) is a feature allowing you to switch off
transmission before entering a Radio-Frequency (RF)
sensitive area. To activate this feature, press the Menu
button and select More > Networks > TXI Mode > Activate.
Press the Yes key to deactivate the TXI Mode. If the CM5000
was previously used in Trunked Mode, it will register to the
network. If the CM5000 was previously used in Direct Mode,
it will remain in Direct Mode.
Press No in Trunked Mode and the CM5000 powers down.
Press No in Direct Mode and you remain in Direct Mode with
TXI selected.
Unlocking the CM5000
Your CM5000 may be locked at power up.
To unlock the CM5000 after powering on, enter the code at
the prompt. The CM5000 enters the default Home display.
The unlock code is originally set to 0000. Your Service
Provider may change this number before you receive your
terminal.
Selecting Your Network
Before you start operating your CM5000, you can select the
network you want your CM5000 to be registered to. For
detailed information, see “Networks” on page 57.
The terminal powers On and Off without visible and audible
notification if Silent Emergency Mode is activated.
WARNING: Pressing the Emergency button, even if Transmit
Inhibit is activated, causes the CM5000 to transmit immediately.
The CM5000 must NOT be within the RF sensitive area when
entering Emergency Operation.
!!
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 101 102

Commentaires sur ces manuels

Pas de commentaire