Motorola LD-W-1 Spécifications télécharger pdf (Page 16)

LD-G-1 / LD-W-1 English

Page 33

Possible cause: The connection of the motor is connected to

locomotive ground.

à Disconnect the connection from locomotive ground.

§ The locomotive lighting does not correspond to its direction of travel.

Possible cause: The forward and backward light connections have

been exchanged.

à Check the connections.

Possible cause: The connections of the motor to the points X11 and

X12 have been exchanged.

à Exchange the connections.

§ A lamp flickers (this is not a defect).

Possible cause: The lamp is connected with one side to locomotive

ground.

à If you do not want the lamp to flicker, disconnect it from

locomotive ground, insulate it and connect it to the return

conductor (point X3).

§ The locomotive does not run.

Possible cause: The locomotive address is not set correctly.

à Check the solder bridges (if necessary with a magnifiying glass).

Possible cause (locomotive with LD-W-1): The connections to the

rails (points X1 and X2) have been exchanged.

à Exchange the connections.

If you cannot find the problem, please return the decoder for repair

(address on the cover page).

Manufacturer's note

According to DIN VDE 0869, the person who builds this kit or brings the

circuit into operation is the manufacturer of the product. If he sells the

product to another person he is responsible for passing on all the

relevant papers. Domestic appliances assembled from a kit are deemed

industrial products and must comply with health and safety regulations.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

Pas de commentaire

Motorola LD-W-1 Spécifications Page 16