Motorola LD-W-1 Spécifications Page 16

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 22
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 15
LD-G-3 / LD-W-3 English
Page 35
Skipping single menu points
If you want to skip single menu points set the speed control knob to
"0", and switch the function "function" on and off once. The decoder
retains the driving characteristics that have already been saved. The
decoder confirms the finishing of a menu point by flashing the front
lamp of the locomotive. Depending on which menu point you finish, it
flashes two, three or four times.
Reset
If you want to restore the data set in state of delivery you press the
analogue driving transformer direction switch and hold it there until the
light of the locomotive, after four flashes and a short break, starts to
flash quickly. Please note that a reset is performed on all locomotives
with this decoder type on the programming track.
If it is only the problem that a locomotive does not react on a certain
address or you have forgotten the address, you do not need to perform
a reset. As you do not have to enter the old address for programming
you can just programm the address as described in the section
"Programming the locomotive address".
Operation
Acceleration and brake delay
In Motorola II format the acceleration and brake delay is switched
alternately on or off by switching on the function F3. The change of the
setting takes effect immediately. If the acceleration and brake delay is
switched off during braking the locomotive immediately runs with the
speed level set at the central unit.
In Motorola I format the acceleration and brake delay is always active.
An emergency stop during acceleration and brake delay can be
performed from the central unit by changing the direction of travel.
Vue de la page 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Commentaires sur ces manuels

Pas de commentaire