Motorola LD-W-1 Spécifications télécharger pdf (Page 18)

LD-G-3 / LD-W-3 English

Page 37

§ The locomotive lighting does not correspond to its direction of travel.

Possible cause: The forward and backward light connections have

been exchanged.

à Check the connections.

Possible cause: The connections of the motor to the points X10 and

X11 have been exchanged.

à Exchange the connections.

§ A lamp flickers (this is not a defect).

Possible cause: The lamp is connected with one side to locomotive ground.

à If you do not want the lamp to flicker, disconnect it from

locomotive ground, insulate it and connect it to the return

conductor (point X1 resp. X6).

§ The locomotive does not run in digital mode.

Possible cause: The locomotive address is not set correctly.

à Programm the locomotive address again (see section

"Programming the locomotive address").

§ The locomotive does not run in analogue mode.

Possible cause: The locomotive is set to digital mode.

à Change to analogue mode.

If you cannot find the problem, please return the decoder for repair

(address on the cover page).

Manufacturer's note

According to DIN VDE 0869, the person who builds this kit or brings the

circuit into operation is the manufacturer of the product. If he sells the

product to another person he is responsible for passing on all the

relevant papers. Domestic appliances assembled from a kit are deemed

industrial products and must comply with health and safety regulations.

Certification

This product conforms with the EC- directive 89/336/EWG on

electromagnetic radiation and is therefore CE certified.

1 2 ... 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

Motorola LD-W-1 Spécifications Page 18