Motorola LD-W-1 Spécifications télécharger pdf (Page 11)

LD-G-1 / LD-W-1 English

Page 39

Required tools and materials

Make sure you have the following tools, equipment and materials ready

for use:

§ an electronic soldering iron (max. 30 Watt) with a fine tip,

§ a soldering iron stand,

§ a tip-cleaning sponge,

§ a heat-resistant mat,

§ a small side cutter and wire stripper,

§ a pair of tweezers,

§ tin solder (0,5 mm. diameter),

§ wire (diameter: > 0,05 mm² for all connections).

Safe and correct soldering

Caution:

Incorrect soldering can cause dangers through fires and heat. Avoid

these dangers by reading and following the directions given in the

chapter Safety instructions. If you have had training in soldering you

can skip this chapter.

§ Use a small soldering iron with max. 30 Watt. Keep the soldering tip

clean so the heat of the soldering iron is applied to the solder point

effectively.

§ Only use tin solder SN 60 Pb (i.e. 60 % tin, 40 % lead) with rosin-

based flux.

§ When soldering electronic circuits never use soldering-water or

soldering grease. They contain acids that can corrode components

and copper tracks.

§ Solder quickly: holding the iron on the joints longer than necessary

can destroy components and can damage copper tracks or

soldering eyes.

§ Apply the soldering tip to the soldering spot in such a way that the

wire and the soldering eye are heated at the same time.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Pas de commentaire

Motorola LD-W-1 Spécifications Page 11