Motorola LD-W-1 Spécifications télécharger pdf (Page 7)

LD-G-1 / LD-W-1 English

Page 35

Operation overview

The decoder is designed for operation in Motorola II format and can be

adjusted to one of 255 addresses. It evaluates the digital data sent by the

central unit to its address and transmits it to the locomotive.

In Motorola I format it is possible to operate the decoder, but the

programming of the parameters and the controlling of the functions is

restricted.

Function speed level and direction of motion

The speed level set at the central unit and the change-direction

command are transmitted to the locomotive by the decoder. At a

direction change command, the current direction of travel is saved.

Velocity characteristic

The decoder can be adjusted to the

individual driving characteristics of the

motor and the characteristic speed of the

locomotive type, by setting the starting

velocity and the maximum velocity. From

the starting velocity and the maximum

velocity the decoder generates a velocity

characteristic corresponding to the opposite

figure. This characteristic allows a good fine

tuning of the speed in the lower speed

range.

Second velocity characteristic

It is possible to program a second velocity characteristic (e.g. for

shunting operation). You can switch between the two velocity

characteristics by operating the function key F4.

Acceleration and brake delay

It is possible to program the acceleration and brake delay individually

via the central unit. When the function F4 is switched on, the

x = speed grade

y = motor voltage

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Pas de commentaire

Motorola LD-W-1 Spécifications Page 7