Page 1 of 4
Connecting the ProMark3 with a Motorola V195/ MOTO RZR with T-
Mobile Activation
Cingular Settimgs are Highlighted in Orange
* ProMark3 OS F/W 2.13 / EBoot V1.19 / GPS FW Version P008 / Base Map V2.01*
Note: Steps 1-7 are done once to setup your specific telephone . Thereafter, you will
start at Step 8 for your connection.
Step 1
On the Motorola V195:
Turn on the Motorola V195 and Press the circular center (Menu/Select) button:
♦ Go to Settings icon (screwdriver and wrench picture) and press Select key
♦ Go to Connection Icon and press Menu/Select key
♦ Highlight the Bluetooth icon and press Menu/Select key
♦ Go to Setup, Set Power to “On”
♦ Name the phone something recognizable like “MOTOJOE”
♦ Back - PREPARE TO PRESS Find Me (Select) BUT NOT YET.
Step 2
On the ProMark3:
Settings – Bluetooth Manager (wait for it to load, may take 15 seconds or so.)
Press Select “Find Me” on the Motorola phone now.
Tap the “Flashlight” to search for your MOTO. At the end of the sequence, look for the phone
icon in the BlueTooth Manager Window.
Tap and HOLD the phone icon
♦ Select Pair
♦ Enter a one or two digit number (suggest 00) for the PIN on the MMCE (activate the
keyboard for this)
♦ The MOTO will request ”Bond with WindowsCE?” Press “Yes”
♦ Enter the same PIN number as above – “OK”.
♦ When the MOTO and the MMCE have been successfully paired, there will be a yellow
circle with a black padlock over the named phone icon on your ProMark3.
Step 3
For next step it is imperative you leave the phone on but on the ProMark3, X out of Bluetooth
Manager and Control Panel, shut the ProMark3 off through “Full Shut down Mode” then restart
the PM3 and re-enter Bluetooth Manager.
Step 4
Tap the “Flashlight” to bring up the Paired and named phone icon and wait for it to finish
searching.
Commentaires sur ces manuels