Motorola MPC564EVB Manuel d'utilisateur Page 24

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 98
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 23
1-14 MPC564EVB Users Manual
Communication Ports
1.4.3 10/100T Ethernet Port
The MPC564EVB has an Ethernet controller (SMSC LAN91C111 U20) operating at 10M bits/sec
or 100Mbits/sec (see the device data sheet on the support CD forr operation details). The dBUG
ROM monitor is programmed to allow a user to download files over a network to memory in
different formats. The compiler-formats currently supported are S-Record, COFF, ELF, or Image
(raw binary). Refer to Appendix B, Configuring dBUG for Network Downloads, for details on
how to configure the board for network download.
The Ethernet registers are located at chip select CS3 base address in the address range 0x0000 -
0x000F. The access is 16 bits wide or half word transfers only. The LAN91C111 device applies a
register bank selection technique to provide a minimum memory space size. Users should review
the device data sheet in detail for operation notes. The debug monitor applies the Ethernet for file
downloads only, no high level stacks are applied in the sample source code.
RJ45 jack J3 of the Ethernet port provides a direct to HUB type connection. The Ethernet cable
provided with the MPC564EVB kit is a crossover type for direct connection of the EVB to a PC
host network card. If connection to a HUB is desired, a standard Ethernet cable should be applied.
Table 1-5. Ethernet Jack J3
100_IRQ Option Jumper
The 100_IRQ Option jumper provides Ethernet Interrupt capability to the MPC564 processor.
With the option installed and the LAN91C111 device properly configured, the MPC564 IRQ1
interrupt can be applied to service the port.
LINK and STAT Indicators
The LAN91C111 Ethernet controller provides two indication drivers under software control. The
LINK indicator is driven by the LAN91C111 LEDA output and the STAT indicator is driven by the
LEDB output.
MII Connector
PIN SIGNAL
1TX+
2TX-
3RX+
4 Term 1 75 ohm
5 Term 1 75 ohm
6RX-
7 Term 2 75 ohm
8 Term 2 75 ohm
Frees
cale Semiconductor,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc...
Vue de la page 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 97 98

Commentaires sur ces manuels

Pas de commentaire