Motorola MPC564EVB Manuel d'utilisateur Page 41

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 98
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 40
Chapter 2. Initialization and Setup 2-3
Installation And Setup
2.2 Installation And Setup
The following sections describe all the steps needed to prepare the board for operation. Please read
the following sections carefully before using the board. When you are preparing the board for the
first time, be sure to check that all jumpers and switches are in the default locations. Default
jumper and switch settings are documented on the master jumper table (see Table 1-2). After the
board is functional in its default mode, the Ethernet interface may be used by following the
instructions provided in Appendix B, “Configuring dBUG for Network Downloads.
2.2.1 Unpacking
Unpack the computer board from its shipping box. Save the box for storing or reshipping. Refer
to the following list and verify that all the items are present. You should have received:
MPC564EVB Single Board Computer
MPC564EVB User's Manual (this document)
One RS232 9-pin Serial Cable
One CAT5E Ethernet cable, crossover type
One P&E Micro BDM (Background Debug Mode) “wiggler” cable
MPC5xx support CD with all documents, drawings, source codes, examples, AxIDE
software, and GNU compiler.
25-pin parallel cable (DB32 M/F) for BDM
A selection of demo Third Party Developer Tools and Literature
NOTE:
Avoid touching the MOS devices. Static discharge can and will
damage these devices.
Once you have verified that all the items are present, remove the board from its protective jacket
and anti-static bag. Check the board for any visible damage. Ensure that there are no broken,
damaged, or missing parts. If you have not received all the items listed above or they are damaged,
please contact Axiom manufacturing immediately - for contact details please see the front of this
manual.
2.2.2 Preparing the Board for Use
The board, as shipped, is ready to be connected to a terminal and power supply without any need
for modification. Figure 2-3, Jumper Locations, shows the position of the jumpers and
connectors.
2.2.3 Providing Power to the Board
The board accepts two means of power supply connection, either PWR or TB1. Connector PWR
is a 2.1mm power jack and TB1 is a power clamp connector with inputs of +12VDC, Ground, and
an IGN (ignition) signal. If not using the provided power supply, the board accepts a supply volt-
age of 4 - 26VDC (current 300ma typical at 12VDC input).
Frees
cale Semiconductor,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc...
Vue de la page 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 97 98

Commentaires sur ces manuels

Pas de commentaire