Motorola MPC564EVB Manuel d'utilisateur télécharger pdf (Page 52)

3-2 MPC564EVB User’s Manual

Operational Procedure

Most commands can be recognized by using an abbreviated name. For instance, entering “h” is

the same as entering “help”. Thus, it is not necessary to type the entire command name.

The commands DI, GO, MD, STEP and TRACE are used repeatedly when debugging. dBUG

recognizes this and allows for repeated execution of these commands with minimal typing. After

a command is entered, simply press <RETURN> or <ENTER> to invoke the command again. The

command is executed as if no command line parameters were provided.

An additional function called the "System Call" allows the user program to utilize various routines

within dBUG. The System Call is discussed at the end of this chapter.

The operational mode of dBUG is demonstrated in Figure 3-1. After the system initialization, the

board waits for a command-line input from the user terminal. When a proper command is entered,

the operation continues in one of the two basic modes. If the command causes execution of the

user program, the dBUG firmware may or may not be re-entered, at the discretion of the user’s

program. For the alternate case, the command will be executed under control of the dBUG

firmware, and after command completion, the system returns to command entry mode.

During command execution, additional user input may be required depending on the command

function.

For commands that accept an optional <width> to modify the memory access size, the valid values

are:

• B 8-bit (byte) access

• H 16-bit (half-word) access

• W 32-bit (word) access

When no <width> option is provided, the default width is .W, 32-bit.

The core MPC500 register set is maintained by dBUG. These are listed below:

• GPR0-GPR31

• IP (SRR0 is IP)

• MSR (SRR1 is MSR)

• CR, XER, LR, CTR, DSISR, DAR, DEC

All control registers on MPC500 core are not readable by the supervisor-programming model, and

thus not accessible via dBUG. User code may change these registers, but caution must be exercised

as changes may render dBUG inoperable.

A reference to “SP” (stack pointer) actually refers to general purpose address register one, “GPR1."

3.2 Operational Procedure

System power-up and initial operation are described in detail in Chapter 2. This information is

repeated here for convenience and to prevent possible damage.

3.2.1 System Power-up

• Be sure the power supply is connected properly prior to power-up.

• Make sure the terminal is connected to RS232 COM-1 connector.

Frees

cale Semiconductor,

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

nc...

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 97 98

Commentaires sur ces manuels

Pas de commentaire

Motorola MPC564EVB Manuel d'utilisateur Page 52

Commentaires sur ces manuels

Produits connexes et manuels pour Cartes mères Motorola MPC564EVB