Motorola VC6000 Series Manuel du propriétaire télécharger pdf (Page 12)

10 VC6000 Series Vehicle Computers

Installing a SIM Card (VC6096 only)

Before using the VC6096 in a cellular network, make sure that the

VC6096 is equipped with a Subscriber Identity Module (SIM) card,

obtained form your service provider. The SIM card is a small smart card

that fits into the VC6096. The SIM card holds the personalized

information about the VC6096, including network activation and phone

book entries.

To install the SIM card:

1. Remove the T8 screw that secures the SIM Card Door and open the

door.

2. Position the SIM Card with the contacts facing the back of the

VC6096, and insert into the SIM Slot. The SIM Card corner notch fits

into the slot only one way (See figure below).

3. Use a pen to push the SIM Card inwards to lock.

4. Place the SIM Card Door and secure the T8 Screw.

5. Torque the T8 Screw to 3.4 kgf-cm (3 in-lbs).



NOTE The VC6096 powers on only if the T8 Screw is fully secured.

CAUTION Ensure to torque the T8 screw to seal the VC6096 series

properly. Otherwise, sealing can be compromised.

SIM Card

SIM Slot

SIM Card Door

T8 Screw

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Pas de commentaire

Motorola VC6000 Series Manuel du propriétaire Page 12