Motorola VC6000 Series Manuel du propriétaire télécharger pdf (Page 19)

Quick Reference Guide 17

Mounting the VC6090 on Electric-Powered Lift Trucks

When installing the VC6090 on an electric-powered lift truck with 24V,

36V or 48V batteries, an external 18-75V DC-to-DC converter is

required.

Access Requirements

• Determine the best location for mounting the power converter, taking

into consideration the ease of accessing the power converter and

mounting requirements.

• Make sure that you have access to the power converter’s power-out

connection.

Important Mounting Information

• Mounting surface must be flat and rigid and it must extend evenly for

the entire length of the power converter surface.

• All four mounting holes must be used.

• Use the following mounting hardware to mount the Power Converter:

1.Four stainless steel cap screws, 1/4”-20-X (M6x1.0-X) where X

represents the length of the cap screws.

2.Four 1/4”-20 (M6x1.0) nyloc nuts

3.Four 1/4” (M6) flat washers

• When installing the power converter, care must be taken to ensure that

the mounting surface is fully supported. Additional plates may be

required to achieve this.



NOTE Do not directly connect the VC6090 to the electric lift truck

battery without the DC-to-DC converter.

CAUTION If mounting to a thin surface, a reinforcing plate is

required.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Pas de commentaire

Motorola VC6000 Series Manuel du propriétaire Page 19