Motorola VC6000 Series Manuel du propriétaire télécharger pdf (Page 23)

Quick Reference Guide 21

4. Connect the plug of the AC Cord into a 100-240 V AC / 50-60 Hz

Power Outlet.

5. If installed on an AC-powered Cart, secure the Indoor Power Supply

Unit to the AC-powered Cart.

Ground Polarity

Connecting the Telemetry Cable (VC6096 only)

The following example shows the 6 Pin Deutsch Telemetry Cable (p/n

3071815Y146). For detailed description of all telemetry cables, refer to

VC6000 series Product Reference Guide, p/n 6802986C08-x.

Telemetry Cable

1. Plug the J1 connector into the Auxiliary port of the VC6000 series

(See Back Features on page 7) and fasten the connection screws of

the connector.

2. Plug connectors J2 and J3 to the telemetry receptacles of your vehi-

cle data bus.



NOTE The total length of the power supply cables is 4.3 m (14.1 ft.).

CAUTION The VC6000 series should operate only in negative

ground electrical systems. Check the ground polarity of

the vehicle before starting the VC6000 series installation

to verify that the polarity is correct. Accidentally reversing

the polarity will not damage the VC6000 series, but will

cause the cable fuse to blow.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Pas de commentaire

Motorola VC6000 Series Manuel du propriétaire Page 23