Motorola VC6000 Series Spécifications Page 30

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 164
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 29
2 - 2 VC6000 Series Product Reference Guide
Installing the VC6000 Series in a Vehicle
Guidelines for Routing Cables
Establish a neat route for the cable, staying clear of moving parts or hot surfaces.
Fix the cable to an existing cable runs inside the vehicle using cable ties.
When the cabling must go through a panel, use a suitable cable guard.
When fixing a conduit or a cable on the outside of a vehicle, use P-Clips. Either drill and tap the hole or use a
nut and bolt to secure the clip.
Ensure the cable does not have tight bends. The minimum recommended radius is 6.35 cm (2.5 inches).
Ensure cables do not swing or chafe on the structure. This often requires using cable ties approximately
every one foot, and ensuring the cables do not flex often, especially where they connect to the VC6000
Series.
If you must re-position the VC6000 Series occasionally, ensure there is enough slack in the cable to
accommodate movement without putting tension on the cable.
Take the power from as close to the battery terminals as possible, and avoid using existing wiring.
Ensure that all fuses are as close as possible to the power source.
Use plastic cable ties to secure the cables to the cable tie bracket of the VC6000 (see Figure 2-1)..
Figure 2-1
Cable Tie Bracket
Cable Tie Bracket
Vue de la page 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 163 164

Commentaires sur ces manuels

Pas de commentaire