Motorola VC6000 Series Spécifications Page 31

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 164
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 30
Installation 2 - 3
Connecting the Vehicle Power Cable
To connect the power cable (see Figure 2-2):
1. Disconnect the power terminals from the vehicle battery.
2. Connect the black wire to the vehicle’s negative power source.
3. Connect the green wire to the vehicle’s ignition switch.
4. Connect the red wire to the vehicle’s positive power source. Place a 10 A slow blow fuse inside the fuse holder,
connected in-line with the red wire approximately 4” from the cable end, as shown in the figure below.
5. Connect the cable’s Power Plug to the VC6000 Series Power Connector (PWR) (see Figure 2-2) and turn
clockwise to lock. The length of the cable is 9.8 ft. (3 m).
Figure 2-2
Power Cable
6. When routing wires, slide Shrink Tubing over wires as required.
7. Connect the power terminals of the Vehicle Power Cable to the terminals of the vehicle battery.
Cigarette Lighter Cable
The Cigarette Lighter Cable (see Figure 2-3) is a power extension cord that plugs into a cigarette lighter outlet of
the vehicle. The maximum length of the cable is 8.2 ft. (9.1 m).
Figure 2-3
Cigarette Lighter Cable
CAUTION DO NOT install the VC6000 Series in a vehicle with a positive ground electrical system.
Power - Red Wire
Ground - Black Wire
Ignition - Green Wire
10 A Fuse SLO BLO
Power Plug
Pin 1 - Power
Pin 2 - Ignition
Pin 3 - N.C
Pin 4 Ground
Shrink Tubing
Fuse Holder
10A Fuse SLO BLO
Power Plug
Pin 1 - Power
Pin 2 - Ignition
Pin 3 - N.C
Pin 4 Ground
Vue de la page 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 163 164

Commentaires sur ces manuels

Pas de commentaire