Motorola VC6000 Series Spécifications Page 35

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 164
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 34
Installation 2 - 7
50 Pin Accessory Cable
The 50 Pin Accessory Cable serves as an adaptor cable betwwen the 9 Pin Deutsch Telemetry Cable (P.N
3089906Y63) or 6 Pin Deutsch Telemetry Cable (P.N 3089906Y63) and the VC6000 Series.
1. Connect the cable into the Auxiliary port of the VC6000 Series (see Figure 2-8). Fasten the connector’s
screws.
2. Connect J2, J3 and J4 connectors to the telemetry receptacles of your vehicle data bus.
3. Connect the I/O wires as required (see Table 2-2).
Figure 2-8
50 Pin Accessory Cable
Auxiliary Port Pin layout
For connecting the I/O wires, use the I/O wires lables and the Auxiliary connector pinout detailed in Table 2-2
below.
Table 2-2
Auxiliary Connector Pinout Details
Pin # Name Functionality
1
RD_OUT1 General purpose output port for relay drive (maximum current load 0.5A )
Relay state restors to initial position after Warm or Cold boot.
3
RD_OUT2 General purpose output port for relay drive (maximum current load 0.5A )
Relay state restors to initial position after Warm or Cold boot.
5
RD_OUT3 General purpose output port for relay drive (maximum current load 0.5A )
Relay state restors to initial position after Warm or Cold boot.
7
RD_OUT4 General purpose output port for relay drive (maximum current load 0.5A )
Relay state restors to initial position after Warm or Cold boot.
9
RD_OUT5 General purpose output port for relay drive (maximum current load 0.5A )
Relay state restors to initial position after Warm or Cold boot.
11
RD_OUT6 General purpose output port for relay drive (maximum current load 0.5A )
Relay state restors to initial position after Warm or Cold boot.
15
RD_OUT8 General purpose output port for relay drive (maximum current load 0.5A )
Relay state restors to initial position after Warm or Cold boot.
J1 To VC6000 Series Auxiliary Port
J2 RS232 (D-type -
Male) Connector
I/O Wires: 8 digital inputs, 8 digital outputs, 2 analog inputs, Debug (2 wires for debugging). See label on wires. Maximum
current through wires 0.5 A
J3 RS232 (D-type -
Male) Connector
J4 RS232 (D-type -
Female) Connector
Vue de la page 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 163 164

Commentaires sur ces manuels

Pas de commentaire