Motorola VC6000 Series Spécifications télécharger pdf (Page 11)

Quick Reference Guide 9

• When fixing a conduit or a cable on the outside of a vehicle, use

P-Clips. Either drill and tap the hole or use a nut and bolt to secure the

clip.

• Ensure the cable does not have tight bends. The minimum recom-

mended radius is 6.35 cm (2.5 inches).

• Ensure cables do not swing or chafe on the structure. This often

requires using cable ties approximately every one foot, and ensuring

the cables do not flex often, especially where they connect to the

VC6000 Series.

• If you must re-position the VC6000 Series occasionally, ensure there is

enough slack in the cable to accommodate movement without putting

tension on the cable.

• Take the power from as

close to the battery ter-

minals as possible, and

avoid using existing wir-

ing.

• Ensure that all fuses are

as close as possible to

the power source.

• Use plastic cable ties to secure the cables to the cable tie bracket of

the VC6000.

Connecting the Vehicle Power Cable

To connect the power cable:

1. Disconnect the power terminals from the vehicle battery.

2. Connect the black wire to the vehicle’s negative power source.

3. Connect the green wire to the vehicle’s ignition switch.

4. Connect the red wire to the vehicle’s positive power source. Place a

10 A SLO BLO fuse inside the fuse holder, connected in-line with the

Red Wire approximately 10 cm (4 inches) from the cable end.

CAUTION DO NOT install the VC6000 Series in a vehicle with a

positive ground electrical system.

Cable Tie

Bracket

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Pas de commentaire

Motorola VC6000 Series Spécifications Page 11