Motorola VC6000 Series Spécifications télécharger pdf (Page 13)

Quick Reference Guide 11

2. Plug connectors J2 and J3 to the telemetry receptacles of your vehi-

cle data bus.

3. Connect the I/O Wires as required.

Grounding

Mounting the Combination Antenna (VC6096 only)

The Combination Antenna is an optional omni-directional WWAN and

WLAN antenna used with the VC6096. The antenna mounts

inside/outside the vehicle cabin or indoors/outdoors.

The antenna has two external RF connectors that connect to the

VC6096 via two low loss RF coax cables.

NOTE For Input/Output (I/O) Wires connections, refer to the VC6000

Series Product Reference Guide.

CAUTION The VC6000 Series should operate only in negative

ground electrical systems. Check the ground polarity of

the vehicle before starting the VC6000 Series installation

to verify that the polarity is correct. Accidentally reversing

the polarity will not damage the VC6000 Series, but will

cause the cable fuse to blow.

J1 - To VC6000 Series Auxiliary port

J2 - RS232 Connector

J3 - Deutsch 6

pin Telemetry

Connector

Telemetry Cable

I/O Wires: 8 digital inputs, 8 digital outputs, 2 analog

inputs, Debug (2 wires for debugging). See label on

wires. Maximum current through wires 0.5 A

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Pas de commentaire

Motorola VC6000 Series Spécifications Page 13