SG4-DRT-2X
The SG4-DRT-2X uses 10-bit A/D technology to double the return bandwidth
capacity and allows system operators to segment Starline
®
SG4000
node locations. The 2X Time Domain Multiplexing (TDM) system
enables you to split the node return path traffic in half, treating each
half as a separate return path stream. Both streams are combined on a
single transmitter for optimum utilization of fiber. You can also install
an additional transmitter to provide equipment and path redundancy.
The SG4-DRT-2X transmitter module uses a state-of-the-art isolated,
cooled, Distributed Feedback (DFB) laser for improved link performance.
These transmitters use lasers based on the International
Telecommunications Union (ITU) frequency grid plan spaced at 100 GHz.
The system is completely scalable and can be expanded from a single
transmitter/receiver to groups of 4, 8, 16, or 32 wavelengths over a
single fiber with the use of muxing and demuxing equipment. The system
is compatible with Motorola low noise optical amplifiers (EDFAs),
allowing network designs that cover large geographical areas. Without
amplification, the Motorola 2X DWDM digital return system is capable
of achieving a link loss budget of 26 dB.
Each module accepts two unique 5-65 MHz return signals at its input.
Each input is digitized with a high-speed A/D converter and then
converted into a 3.1Gbps TDM data stream that drives the laser. The
optical detector, together with the demultiplexer, decoder, and amplifier
are contained in the Omnistar
®
GX2-DRR-2X digital return receiver.
MOTOROLA DIGITAL RETURN SYSTEM
STARLINE
®
SG4-DRT-2X Transmitter
OmniStar
®
GX2-DRR-2X Receiver
With the implementation of time division
multiplexing, Motorola’s 2X digital return
simplifies node segmentation in the
Starline
®
SG4000.
BENEFITS INCLUDE:
• 5-65 MHz Return Path Operation
• High optical output power +8 dBm
• Excellent noise power ratio (NPR) 40/11
• Easy upgrade path for node segmentation
• 40 DWDM wavelengths available
• Downloadable firmware
• Plug-n-Play installation and operation
The SG2-DRT-2X features an enable/fault LED to report local status
information. An integrated optical bulkhead connector provides simple,
quick-connect module installation and facilitates easy connector
cleaning. All necessary cables required to install the SG4-DRT-2X in
SG4000 nodes are included with every transmitter.
To facilitate easy upgrades, the SG4-DRT-2X has the same set-up
levels as the analog return transmitters. The double-wide module
occupies the same locations as two analog transmitters in the node
lid.
Commentaires sur ces manuels