CPX8216 and CPX8216T Installation and Use (6806800A52C)
Chapter 9 Subassembly Removal and Installation
98
Floppy Housing Removal and Installation
The floppy housing is located in the rear of the chassis. It can accommodate up to two floppy
drives and two SCSI connectors.
The floppy housing is not hot swappable.
Removal
Refer to the next figure and follow these steps to remove the floppy housing from the chassis.
1. Shut down the operating system. If the system is configured as a dual-8 system, make sure that
both domains are shut down.
2. Disconnect the external SCSI cable(s) from the back of the floppy housing. If more than one
SCSI cable is installed, mark the cable and associated housing connector for later reinstallation.
3. Turn the chassis power off.
4. Loosen the four captive screws in the corners of the floppy housing.
5. Pull the housing straight out of the chassis.
Installing the Floppy Housing
Refer to the preceding figure and follow these steps to install the floppy housing in your chassis.
Commentaires sur ces manuels