Motorola CPCI-6115 Manuel de service Page 80

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 174
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 79
CPX8216 and CPX8216T Installation and Use (6806800A52C)
Chapter 7 Installing Boards in the Chassis
60
The following table lists the colors and glyphs common to ECC chassis.
Installing a Module
This section describes a recommended procedure for installing a board module in a chassis.
Before you install your module, please read all cautions, warnings, and instructions presented
in this section and the guidelines explained in Before You Install or Remove a Board on page 57.
Use ESD
Wrist Strap
ESD
Handling modules and peripherals can result in static damage. Use a grounded wrist
strap, static-dissipating work surface, and antistatic containers when handling and
storing components.
!
Caution
Caution
Insert the board by holding the injector levers—do not exert unnecessary pressure on
the faceplate.
Hot swap compliant modules may be installed while the system is powered on. If a module is
not hot swap compliant, you should remove power to the slot or system before installing the
module. See Understand Hot Swap on page 58 for more information.
Table 7-1. Slot Usage Indicators
Card Rail
Color
Glyph Usage
Tan none MXP: Alarm Management Controller slot
CPX: Hot Swap Controller or Bridge slot
Red MXP: Fabric Switch Card slot
CPX: System Controller slot
Black MXP: Payload Card slot
CPX: Non-system Controller or I/O Card slot
Vue de la page 79
1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 173 174

Commentaires sur ces manuels

Pas de commentaire