Motorola CPCI-6115 Manuel de service Page 98

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 174
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 97
CPX8216 and CPX8216T Installation and Use (6806800A52C)
Chapter 8 Drive Removal and Installation
78
Replacing a Hot Swap SCSI Drive Module
Follow these steps to remove a SCSI drive module from the chassis enclosure. This is in
preparation for replacing a drive module.
!
Caution
Caution
Prior to removing power from the SCSI drive, shutdown any running processes and the
operating system. This will help prevent any data loss or damage to the operating
system.
1. Push in the keyswitch and turn it counterclockwise 1/4 turn. This alerts the system that the drive
is about to be removed and unlocks the drive module from the carrier frame.
Note Do not remove the drive module when the green LED is illuminated. When the drive
module is ready to be removed, the green status LED goes out and the yellow status LED
illuminates, indicating that the drive is off-line and ready to be removed.
The status LED activity is controlled by the system software. This procedure describes a typical
configuration of the status LEDs. Your system may be configured differently, and the status
LEDs may not function as indicated.
2. When the yellow status LED is illuminated and the drive ceases to spin, pull the drive module
straight out of the drive bay.
3. Pull off the top and bottom covers from the drive carrier.
4. Remove the four mounting screws from the sides of the drives.
5. Push the drive up through the carrier and disconnect all signal and power cables from the drive.
6. Configure the replacement drive.
2418 9811
Vue de la page 97
1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 173 174

Commentaires sur ces manuels

Pas de commentaire