Motorola CPCI-6115 Manuel de service Page 67

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 196
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 66
Controls, LEDs, and Connectors
CPCI-6200 Installation and Use (6806800J66C)
67
3.4.2 Reset/Abort Switch, P2
There is one push button switch located on the front panel that provides access to board reset
and abort function.
This is a multifunction switch. When the switch is pushed for one to three seconds, an abort is
issued. When switch is pushed for five or more seconds, it is treated as reset function.
3.5 Front Panel LEDs
The CPCI-6200 provides two physical (three logical) LEDs on the front panel.
The blue LED indicates hot swap status, and is used during board insertion and extraction.
The second LED is a bi-color LED: green and yellow.
The green LED is completely controlled by the user through the programmable register
Front Panel LEDs Control and Status Register.
The yellow LED indicates failure. The yellow LED lights up when any one or more of the
following conditions occur:
HRESET is asserted.
+5 V supply failed (5V_PGOOD signal is low).
The system watchdog times out.
A user has set bit 0=0 in Front Panel LEDs Control and Status Register.
Table 3-18 Front Panel Reset Switch Pinout, P2
Pin Number Signal
1FP_SWITCH
2GND
Vue de la page 66
1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 195 196

Commentaires sur ces manuels

Pas de commentaire