Motorola CPCI-6115 Manuel de service Page 81

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 196
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 80
Functional Description
CPCI-6200 Installation and Use (6806800J66C)
81
4.10.3 USB (PCI Bus 4)
The USB 2.0 host controller (NEC uPD720101) provides USB ports with integrated transceivers
for connectivity with any USB-compliant device or hub. USB channel 1 is routed to a single USB
connector located on the front panel. DC power to the front panel USB port is supplied via a
USB power switch. This power switch provides soft-start, current limiting, over current
detection, and power enable for port 1.
4.10.4 PCI Bus Frequency
PCI 1 and 2 buses can operate from 33 MHz to 133 MHz depending on the PMC. The following
table shows the frequency selection and supported configurations. The switch setting is
controlled by the user while the rest of the signals are set automatically by the hardware.
4.11 Operation Modes
CPCI-6200 can be operated in three modes, with the PCI to PCI bridge (PCI6466) behaving
differently in each mode.
Table 4-1 PCI Buses 1 and 2 Frequency Requirements
Mode and Bus Rate
Switch S1,
Position 5
1
PCI_PCIXCAP PCI_SEL100 PCI_M66EN Note
PCI 25 MHz ON GND 1 0 Supported
PCI 33 MHz OFF GND 0 0 Supported
PCI 50 MHz ON GND 1 1 Supported
PCI 66 MHz OFF GND 0 1 Supported
PCI-X 50 MHz OFF 10K to ground 1 1 Not Supported
PCI-X 66 MHz OFF 10K to ground 0 1 Not Supported
PCI-X 100 MHz OFF HIGH 1 1 Supported
PCI-X 133 MHz ON HIGH 0 1 Supported
1. Switch S1, Position 5 selects PCI 1 bus frequency, while Switch S2, position 8 selects PCI 2 bus frequency.
Vue de la page 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 195 196

Commentaires sur ces manuels

Pas de commentaire