Motorola F5207A, F5217A Guide d'installation télécharger pdf (Page 13)

Installation

This section describes the tools and equipment, planning requirements, and product

inspections necessary for a smooth installation of the Mobile Workstation 800 (MW 800).

Proper planning will help to ensure that the installation is completed without difficulty and

that no damage occurs to the units or the vehicle.

Unpacking

Carefully unpack each item from the shipping carton. Check all items for shipping damage,

and make sure you have received all items ordered.

If there is damage or missing items, retain the shipping carton for inspection.

The following parts are used to mount the MW 800:

• Mount assembly

• CPU box mount kit for the MW 800 CPU V056AQ (optional)

• Mobile Workstation MW 800 Vehicle Installation Guide, 68P02967C20

Preparing to Install the MW 800 Inside the Vehicle

Tools

The following tools and service aids are required for installation:

• 3/8” nut driver

• 1/2”, 3/8” or 7/16” wrench

• No. 2 and 4 Phillips screwdriver

• Drill with 3/16” drill bit

Planning

Be sure to consider the following issues when planning the installation:

• Keyboard and display location relative to air bag deployment zones

• Environmental considerations

• Electrical guidelines

• Liquid Propane (LP) gas warning

The MW 800 is a reliable product when installed correctly. However,

performance can be seriously impaired if it is not installed correctly.

Thoughtful planning can make the difference.

Please note that installing any part of the MW 800 must be according to

the instructions provided in this manual or by SDI.

Caution

Warning

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 54 55

Pas de commentaire

Motorola F5207A, F5217A Guide d'installation Page 13