Motorola F5207A, F5217A Guide d'installation Page 17

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 55
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 16
Installation 11
Environmental Considerations
Consider the environmental parameters listed in the General Specifications section before
installing the MW 800.
.
Electrical Guidelines
Be sure that the vehicle’s electrical system is in good condition. Faults in the alternator and
ignition system can be a source of severe Radio Frequency Interference (RFI) and can result
in MW 800 operating problems. Correct any problems in the alternator output, ignition
system, and battery condition before beginning the installation.
The power requirement for operating the MW 800 is 13.8VDC +/- 20%, 15A, negative
ground. The vehicle must have an alternator that can produce a high-current output at low
speed (below 18 m.p.h. or 29 km/h) and in an idle state. It also needs the highest rated heavy-
duty battery available for the vehicle. The power cables of the MW 800 should be directly
connected to the power system of the vehicle.
Cables longer than 10 ft. (3.05 m) should be routed through special UL listed conduit/duct
for electrical cables. This conduit/duct should fully enclose the cable along its whole length.
Mobile Antenna Installation
Vehicle antennas must be installed external to the vehicle and in accordance with:
The requirements of the antenna manufacturer/supplier.
Instructions in the installation manual of the external radio (in case an external radio is
used).
For operation in hot climates, the vehicle must be adequately
ventilated (for temperatures see General Specifications section).
!
Caution
DO NOT install the workstation in a vehicle with a positive-ground
electrical system.
Avoid using power Battery Saver relays that cut-off power ruthlessly
between the MW 800 main power and the power system of the vehicle.
Uncontrolled power cut-off can damage the MW 800 operating system
and may require re-imaging of the hard drive. If a power cut-off device
is used in order to conserve vehicle battery life, please consult a
qualified Motorola authorized installation shop or contact the Motorola
system support center for assistance..
!
Caution
!
Caution
Vue de la page 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 54 55

Commentaires sur ces manuels

Pas de commentaire