Motorola MVME2400 Series Manuel de service Page 221

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 354
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 220
Functional Description
http://www.mcg.mot.com/literature 3-35
3
Refresh/Scrub
The SMC performs refresh by doing a burst of 4 CAS-Before-RAS (CBR)
refresh cycles to each block of SDRAM once every 60us. It performs
scrubs by replacing every 128th refresh burst with a read cycle to 8 bytes
in each block of SDRAM. If during the read cycle, the SMC detects a
single-bit error, it performs a write cycle back to SDRAM using corrected
data providing the SWEN control bit is set. It does not perform the write if
the SWEN bit is cleared. If the SMC detects a double-bit error, it does not
perform a write.
If so enabled, single- and double-bit scrub errors are logged and the
PowerPC 60x bus master is notified via interrupt.
CSR Accesses
The SMC has a set of control and status registers (CSR) that allow software
to control certain functions and to monitor some status.
External Register Set
The SMC has an external register chip select pin which enables it to talk to
an external set of registers. This interface is like the ROM/Flash interface
but with less flexibility. It is intended for the system designer to be able to
implement general-purpose status/control signals with this external set.
Refer to the section on SMC Registers, further on in this chapter, for a
description of this register set.
The SMC has a mode in which two of its pins become control register
outputs. When the SMC is to operate in this mode, the External Register
Set cannot be implemented. The two control bits appear in the range where
the External Register Set would have been had it been implemented.
Chip Configuration
Some configuration options in the Hawk must be configured at power-up
reset time before software performs any accesses to it. The Hawk obtains
this information by latching the value on some of the upper RD signals just
Vue de la page 220
1 2 ... 216 217 218 219 220 221 222 223 224 225 226 ... 353 354

Commentaires sur ces manuels

Pas de commentaire