Motorola MVME2400 Series Manuel de service télécharger pdf (Page 111)

ENV - Set Environment

http://www.mcg.mot.com/literature 6-9

Network Auto Boot Enable [Y/N] = N?

Network Auto Boot at power-up only [Y/N] = N?

Network Auto Boot Controller LUN = 00?

Refer to the PPCBug Firmware Package User’s Manual for a listing

of network controller modules currently supported by PPCBug.

(Default = $00)

Network Auto Boot Device LUN = 00?

Refer to the PPCBug Firmware Package User’s Manual for a listing

of network controller modules currently supported by PPCBug.

(Default = $00)

Network Auto Boot Abort Delay = 5?

The time in seconds that the NETboot sequence will delay before

starting the boot. The purpose for the delay is to allow you the option

of stopping the boot by use of the

BREAK key. The time value is from

0-255 seconds. (Default = 5 seconds)

Network Auto Boot Configuration Parameters Offset (NVRAM) =

00001000?

The address where the network interface configuration parameters are

to be saved/retained in NVRAM; these parameters are the necessary

parameters to perform an unattended network boot. A typical offset

might be $1000, but this value is application-specific. (Default =

$00001000)

The Network Auto Boot (NETboot) function is

enabled.

The NETboot function is disabled. (Default)

NETboot is attempted at power-up reset only.

NETboot is attempted at any reset. (Default)

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 177 178

Pas de commentaire

Motorola MVME2400 Series Manuel de service Page 111