Motorola MVME2400 Series Manuel de service télécharger pdf (Page 20)

1-4 Computer Group Literature Center Web Site

Preparing and Installing the MVME2400-Series Module

The MVME240x board supports both front panel I/O and rear panel P2 I/O

through either PMC slot 1 or PMC slot 2. 64 pins of I/O from slot 1 and 46

pins of I/O from slot 2 are routed directly to P2.

VMEsystem Enclosure

Your MVME240x board must be installed in a VMEsystem chassis with

both P1 and P2 backplane connections. It requires a single slot, except

when PMCspan carrier boards are used. Allow one extra slot for each

PMCspan.

System Console Terminal

In normal operation, connection of a debug console terminal is required

only if you intend to use the MVME240x’s debug firmware, PPCBug,

interactively. An RJ45 connector is provided on the front panel of the

MVME240x for this purpose.

Overview of Start-Up Procedures

The following table lists the things you will need to do before you can use

this board, and tells where to find the information you need to perform

each step. Be sure to read this entire chapter and read all Caution and

Warning notes before beginning.

Table 1-3. Start-Up Overview

What you need to do ... Refer to ... On page ...

Unpack the hardware. Unpacking the MVME240x Hardware 1-7

Set jumpers on the MVME240x

module.

Preparing the MVME240x Hardware 1-7

MVME240x 1-7

Prepare the PMCs. PMCs 1-13

For additional information on PMCs, refer to

the PMC manuals provided with these cards.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 177 178

Pas de commentaire

Motorola MVME2400 Series Manuel de service Page 20