Motorola MVME2400 Series Manuel de service télécharger pdf (Page 31)

Installing the MVME240x Hardware

http://www.mcg.mot.com/literature 1-15

Figure 1-3. Typical Single-width PMC Module Placement on MVME240x

5. Slide the edge connector(s) of the PMC module into the front panel

opening(s) from behind and place the PMC module on top of the

MVME240x. The four connectors on the underside of the PMC

module should then connect smoothly with the corresponding

connectors for a single-width PMC (J11/J12/J13/J14 or

J21/J22/J23/J24, all eight for a double-width PMC) on the

MVME240x.

6. Insert the two short Phillips screws through the holes at the forward

corners of the PMC module, into the standoffs on the MVME240x.

Tighten the screws.

7. If installing two single-width PMCs, repeat the above procedure for

the second PMC.

2064 9708

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 177 178

Pas de commentaire

Motorola MVME2400 Series Manuel de service Page 31