Motorola MVME2400 Series Manuel de service télécharger pdf (Page 32)

1-16 Computer Group Literature Center Web Site

Preparing and Installing the MVME2400-Series Module

Primary PMCspan

To install a PMCspan-002 PCI expansion module on your MVME240x,

refer to Figure 1-4 and perform the following steps. This procedure

assumes that you have read the user’s manual that was furnished with the

PMCspan, and that you have installed the selected PMCs on the PMCspan

according to the instructions given in the PMCspan and PMC manuals.

1. Attach an ESD strap to your wrist. Attach the other end of the ESD

strap to the chassis as a ground. The ESD strap must be secured to

your wrist and to ground while you are performing the installation

procedure.

2. Perform an operating system shutdown. Turn the AC or DC power

off and remove the AC cord or DC power lines from the system.

Remove chassis or system cover(s) as necessary for access to the

VME module card cage.

Caution

Inserting or removing modules with power applied may result

in damage to module components.

Warning

Dangerous voltages, capable of causing death, are present in

this equipment. Use extreme caution when handling, testing,

and adjusting.

3. If the MVME240x has already been installed in the chassis,

carefully remove it from the VMEbus card slot and lay it flat, with

connectors P1 and P2 facing you.

Caution

Avoid touching areas of integrated circuitry; static discharge

can damage these circuits.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 177 178

Pas de commentaire

Motorola MVME2400 Series Manuel de service Page 32