Motorola AP-7131 - Wireless Access Point Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Routeurs Motorola AP-7131 - Wireless Access Point. Motorola AP-7131 - Wireless Access Point Installation guide Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer

Résumé du contenu

Page 1 - AP-7131 Series Access Point

INSTALLATION AP-7131 Series Access PointInstallation Guide

Page 2

AP-7131 Series Access Point: Installation Guide 42.3 Access Point PlacementFor optimal performance, install the access point away from transformer

Page 3 - Contents

Hardware Installation52.3.1 Antenna OptionsMotorola supports two antenna suites for AP-7131 and AP-7131N models. One antenna suite supporting the 2

Page 4

AP-7131 Series Access Point: Installation Guide 6The 2.4 GHz antenna suite includes the following models:The 5 GHz antenna suite includes the followi

Page 5

Hardware Installation72.3.2 Power Injector SystemThe access point can receive power via an Ethernet cable connected to the GE1/POE (LAN) port.When

Page 6

AP-7131 Series Access Point: Installation Guide 8A separate Power Injector is required for each access point comprising the network. The Power Inject

Page 7 - 1 Introduction

Hardware Installation91. Connect the Power Injector to an AC outlet (110VAC to 220VAC).2. Connect an RJ-45 Ethernet cable between the network data sup

Page 8 - 1.3 Site Preparation

AP-7131 Series Access Point: Installation Guide 10

Page 9 - 2 Hardware Installation

Hardware Installation11To mount the access point on a wall using the provided template: 1. Xerox copy the template (on the previous page) to a blank p

Page 10 - 2.3 Access Point Placement

AP-7131 Series Access Point: Installation Guide 1211. Cable the access point using either the Power Injector solution or an approved line cord and po

Page 11 - 2.3.1 Antenna Options

Hardware Installation132.4.2 Suspended Ceiling T-Bar InstallationsA suspended ceiling mount requires holding the access point up against the T-bar

Page 13 - Hardware Installation

AP-7131 Series Access Point: Installation Guide 14a. Connect a RJ-45 Ethernet cable between the network data supply (host) and the access point’s GE1

Page 14

Hardware Installation1510. Rotate the access point chassis 45 degrees counter-clockwise. The clips click as they fasten to the T-bar.11. The access po

Page 15 - 2.4.1 Wall Mounting

AP-7131 Series Access Point: Installation Guide 16 The mounting hardware required to install the access point above a ceiling consists of:• Light pip

Page 16

Hardware Installation175. Create a light pipe path hole in the target position on the ceiling tile.6. Use a drill to make a hole in the tile the appro

Page 17

AP-7131 Series Access Point: Installation Guide 1813. Align the ceiling tile into its former ceiling space.14. Cable the access point using either th

Page 18

Hardware Installation192.5 LED IndicatorsBoth AP-7131 and AP-7131N model access points have six LEDs on the top of the access point housing, and on

Page 19 - Antenna Options” on

AP-7131 Series Access Point: Installation Guide 202.5.1 Three Radio AP-7131N LEDsA three radio model AP-7131N has the following unique LED behavio

Page 20 - LED Indicators”

Hardware Installation212.5.2 Dual Radio (2.4/5 Ghz) LEDsA dual radio (2.4/5 Ghz) model access point has the following unique LED behavior: LED 1 LE

Page 21

AP-7131 Series Access Point: Installation Guide 222.5.3 Single Radio 2.4 Ghz LEDs A single 2.4 Ghz radio model has the following unique LED behav

Page 22

Hardware Installation232.5.4 Single Radio 5 Ghz AP-7131 LEDs A single 5 Ghz radio model has the following unique LED behavior: LED 1 LED 2 LED 3

Page 23

1.0 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11.1 Document Conventions . . . . . . . . . . .

Page 24

AP-7131 Series Access Point: Installation Guide 242.5.5 Rear AP-7131 LEDThe LED on the rear (bottom) of the access point is optionally viewed usin

Page 25 - 2.5 LED Indicators

Basic Configuration25The login screen displays.2. Log in using admin as the default User ID and motorola as the default password. If the default login

Page 26

AP-7131 Series Access Point: Installation Guide 26access point could be operating illegally unless set to operate in the correct country. Proceed to

Page 27

Basic Configuration271. Select System Configuration -> Quick Setup from the menu tree, if the Quick Setup screen is not already displayed. 2. Selec

Page 28 - Single Radio 2.4 Ghz LEDs

AP-7131 Series Access Point: Installation Guide 28b. Select the Country for the AP-7131’s country of operation. The access point prompts for the corr

Page 29

Basic Configuration29 Radio Button Single Radio SKU Dual Radio SKU Three Radio SKU2.4 GHz WLAN, 5.0 GHz WLAN & SensorNot Available Not AvailableRa

Page 30 - 3 Basic Configuration

AP-7131 Series Access Point: Installation Guide 305. Select the Quick Setup screen’s Network Configuration tab to define a minimum set of WAN or LAN

Page 31 - Basic Configuration

Basic Configuration31c. Specify an IP address for the access point’s WAN connection. An IP address uses a series of four numbers expressed in dot nota

Page 32

AP-7131 Series Access Point: Installation Guide 32to use the access point as a DHCP server over the LAN connection. Select the Bootp client option to

Page 33

Basic Configuration33a. Enter the Extended Services Set Identification (ESSID) and name associated with the WLAN. b. Use the Available On checkboxes t

Page 34

5.0 Regulatory Compliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 416.0 Waste Electrical and Electronic Equipment (WEEE) . . . .

Page 35

AP-7131 Series Access Point: Installation Guide 343.2.1 Configuring Basic SecurityFor testing basic connectivity, there is no reason to configure

Page 36

Basic Configuration353. Select the WEP 128 (104 bit key) checkbox.The WEP 128 Setting field displays within the New Security Policy screen.4. Configur

Page 37

AP-7131 Series Access Point: Installation Guide 36At this point, you can either restrict specific MU access to the access point (using the ACL) or te

Page 38

Basic Configuration37Refer to the Number of Responses value to assess the number of responses from the target MU versus the number of pings transmitte

Page 39

AP-7131 Series Access Point: Installation Guide 384 Specifications4.1 AP-7131 Physical CharacteristicsAn AP-7131 model access point has the follow

Page 40

Specifications394.3 Electrical CharacteristicsThe AP-7131 and AP-7131N model access points have the following electrical characteristics: 4.4 AP

Page 41

AP-7131 Series Access Point: Installation Guide 404.5 AP-7131N Radio Characteristics An AP-7131N has the following radio characteristics: Operati

Page 42

Regulatory Compliance415 Regulatory ComplianceThese devices (AP-7131 and AP-7131N) are approved under the Symbol Technologies brand; Symbol Technologi

Page 43 - 3.3 Where to Go From Here?

AP-7131 Series Access Point: Installation Guide 42Safety in HospitalsWireless devices transmit radio frequency energy and may affect medical electric

Page 44 - 4 Specifications

Regulatory Compliance43Radio Frequency Interference Requirements—FCCThis equipment has been tested and found to comply with the limits for a Class B d

Page 45 - Specifications

vMOTOROLA and the Stylized M Logo are registered in the US Patent & Trademark Office. Symbol is a registered trademark of Symbol Technologies, Inc

Page 46

AP-7131 Series Access Point: Installation Guide 44CE Marking and European Economic Area (EEA)The use of 2.4GHz RLAN’s, for use through the EEA, have

Page 47 - 5 Regulatory Compliance

Regulatory Compliance45Declarações Regulamentares para AP7131N - BrasilNota: A marca de certificação se aplica ao Transceptor, modelo AP-7131N. Este

Page 48 - Wireless Devices - Countries

AP-7131 Series Access Point: Installation Guide 46Wireless device operate in the frequency band of 5.25-5.35 GHz, limited for Indoor use only.在 5.25-

Page 49 - Radio Transmitters

Waste Electrical and ElectronicEquipment (WEEE)476 Waste Electrical and Electronic Equipment (WEEE)English: For EU Customers: All products at the end

Page 50 - Statement of Compliance

AP-7131 Series Access Point: Installation Guide 48Nederlands: Voor klanten in de EU: alle producten dienen aan het einde van hun levensduur naar Symb

Page 51

Motorola’s Enterprise Mobility SupportCenter497 Motorola’s Enterprise Mobility Support CenterIf you have a problem with your equipment, contact Enterp

Page 52

AP-7131 Series Access Point: Installation Guide 508 AP-7131 Series ROHS Compliance O:表示该有毒有害物质在该部件所有均质材料中的含量均在 SJ/T11363-2006 标准规定的限量要求以下。X:表示该有毒有害物质

Page 54

MOTOROLA INC1303 E. ALGONQUIN ROADSCHAUMBURG, IL 60196http://www.motorola.com72E-124099-01 Revision AJuly 2009

Page 56

Introduction11 IntroductionAs a standalone access point, an AP-7131 series access point provides small and medium-sized businesses with a consolidated

Page 57

AP-7131 Series Access Point: Installation Guide 21.1 Document ConventionsThe following graphical alerts are used in this document to indicate nota

Page 58

Hardware Installation32 Hardware InstallationAn AP-7131 or AP-7131N access point installation includes mounting the access point, connecting the acces

Commentaires sur ces manuels

Pas de commentaire