Motorola TIME WARNER DCT6208 Guide de l'utilisateur télécharger pdf (Page 43)

DCT6200/DCT6208 User Guide

TROUBLESHOOTING

Before calling your service provider, review this troubleshooting guide.

This information is to help you quickly solve a problem. If your problem

still exists, contact your service provider.

Problem Possible Solution

The DCT* will not

power on

Verify that the AC power cord is connected to the DCT*

and an AC outlet.

If the DCT* is connected to a switched outlet on another

unit, verify that that unit is powered on.

Press the

POWER button on the DCT* front panel instead

of the remote control. The batteries in the remote control

may be depleted.

The DCT* may have received a software update and

may not power on while the new software is being

installed. Try again in a few minutes.

The remote control

does not work

Verify that the remote control is in “Cable” mode.

Verify that there are no obstructions between the remote

control and the DCT*. Aim the remote control directly at

the DCT* front panel, not the TV or VCR.

The angle between the remote control and the DCT*

may be too large. Stand in front of the DCT* and not too

far to either side.

Press and release operation keys one at a time, firmly

and deliberately.

Try changing channels using the buttons on the DCT*

front panel.

Check the batteries in the remote control. Install new

batteries if needed.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 49

Pas de commentaire

Motorola TIME WARNER DCT6208 Guide de l'utilisateur Page 43