Motorola MICOM-2TS Spécifications Page 38

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 76
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 37
MICOM-2ES/2RS/2TS ALE Supplement to Owner’s Guide
Transmitting Calls in ALE Mode
To transmit an ALE call, you must specify the destination. In general, the destination
consists of a net and one or more stations (members of the specified net):
When the MultiNet function (page 12) is disabled, the destination net is always
the currently selected net (its number is displayed on the LCD while the radio is
scanning). Therefore, if you do not want to select a different net, you can skip
directly to the selection of the destination station(s).
When the MultiNet function is enabled, first you must always select a net and
then the destination station(s).
To expedite the transmission of an AllCall, you can send a global AllCall by pressing
the P/ESC key for a few seconds.
MICOM-2 stores the last called address, so you can simply press the PTT twice in
rapid sequence (double pressing) to call again that address. This also applies to
AllCall, and therefore after sending AllCall for the first time, you can send it again
by double pressing the PTT.
Note
If you want to monitor the call set up process on the speaker and
be alerted by a beep when the link is set up, turn the monitor on,
using the MON (F4) key.
Selecting the Desired Net
To select a net:
1. Press MENU and select ALE (F3).
The radio displays current active net number,
flashing.
ALE
NET# 7
MOTOROLA
2. To change the currently used net, press the
UP/DOWN keys, or enter the net number on the
keypad, and then press ENTER.
ALE
NET 1 1
MOTOROLA
CALL LQA MON
24
_________________________________________________________________________________________________
Vue de la page 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 75 76

Commentaires sur ces manuels

Pas de commentaire