Motorola MICOM-2TS Spécifications télécharger pdf (Page 54)

MICOM-2ES/2RS/2TS ALE Supplement to Owner’s Guide

➤ To define or change a group:

1. Press CALL (F1) and select the GRP option, as you do to start a group call

(page 38).

2. The first group displayed is always group 1. If this

is the group you want, skip directly to Step 3 below,

otherwise press the UP or DOWN arrows until you

see the desired group.

CALL

GRP 1

MOTOROLA

SEND PAGE CHAN SELs

3. To select the stations you want in this group, press SEL (F4).

Note

The following example explains how to build a new group, but you

can use the same procedures to change an existing group.

4. After pressing SEL (F4), you will see the DIR

screen. Therefore, you can select stations from the

addresses already stored in the directory, or type

new addresses using the keypad.

DIR

1005

MOTOROLA

ADD PAGE CHAN OKs

To select an address from these already in the directory:

• Use the UP and DOWN arrows to display the desired directory entry,

and then press ADD (F1).

The label above the selected entry changes to

ADDED, to indicate that it is now included in

the group.

Now you can also have the option (ERAS (F1))

to delete the entry from the group.

ADDED

1007

MOTOROLA

ADD ERAS CHAN OKs

Note

If adding the station would cause the

total length of the station addresses in

the group to exceed 12 ALE words, then

after pressing ADD (F1) you will see

BUFF FULL and the process stops.

GROUP

BUFF FULL

MOTOROLA

ADD ERAS CHAN OKs

• Repeat the procedure described above until the

group includes only the desired stations.

_________________________________________________________________________________________________

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 75 76

Commentaires sur ces manuels

Pas de commentaire

Motorola MICOM-2TS Spécifications Page 54

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Motorola MICOM-2TS