Motorola MICOM-2TS Spécifications Page 56

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 76
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 55
MICOM-2ES/2RS/2TS ALE Supplement to Owner’s Guide
Double selective: similar to selective, except that you specify the last two
characters of the address.
To make an AnyCall, first you must select the address to be used for the call.
MICOM-2 will wait for responses for a certain time before entering the link state
with all the stations that responded within this interval (the maximum number of
stations that are accepted in an AnyCall is 16).
Note
Before starting, you may want to select a different net to use: see
instructions on page 24.
When MultiNet is enabled, you will be prompted for a net number
as soon as you press CALL (F1) to start a call.
To transmit an AnyCall:
1. Press CALL (F1).
The radio displays the last called address.
If you see the address you want (that is, you want to
repeat the last AnyCall), skip directly to Step 10
below, otherwise continue as explained below.
CALL
1001
MOTOROLA
SEND PAGE CHAN MONs
2. Press MORE once.
CALL
1001
MOTOROLA
MULT PAGE CHAN MONs
3. Press MULT (F1) to display the first page of special
calls.
CALL
MOTOROLA
ALL NET GRP ANYs
4. Press ANY (F4).
CALL
ANY
MOTOROLA
SEND PAGE CHAN SELs
5. Press SEL (F4).
ALL
ENDING:_
MOTOROLA
? PAGE CHAN MONs
Note
If you try to send (SEND (F1)) the call without first selecting an
address, your attempt is rejected and you see for a few seconds
NOT PROG.
42
_________________________________________________________________________________________________
Vue de la page 55
1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 75 76

Commentaires sur ces manuels

Pas de commentaire