Motorola MICOM-2TS Spécifications télécharger pdf (Page 73)

ALE Programming

ALE Options Configuration

This menu enables you to configure the following ALE options:

• PTOT

PTT Timeout: the time (in minutes) which elapses between the

moment you release the PTT button, until the ALE disconnects the

link. The allowed range is 1 to 10 minutes.

• EXAL

External Alarm: activate/deactivate the radio external alarm when a

call is received.

• ALRT

Alert tone: enable/disable the generation of an alert tone whenever a

link is established.

• TOT

Accept Link Time-out Time: the radio can be configured to

disconnect the link automatically if neither the PTT, nor any other

key is pressed within 30 seconds from the reception of a call. If

Accept Link TOT is set to NO, the received call is accepted

immediately and automatically.

• MLQA

Minimum LQA Score: determines the minimum acceptable LQA

(Link Quality Analysis) score allowed when trying to establish a link

on a specific channel.

If the minimum score is not achieved when the radio attempts to

establish a link in the ALE mode, the radio will try to establish a link

on the scanned channel with the next best LQA score. At the end of

this process, a link will be established on the scan channel with the

best LQA score. If the call is made on a specific channel, the radio

ignores the minimum LQA score check.

The allowed range of LQA scores is 0 to 100%. When selecting the

minimum LQA score, remember that in accordance with the ALE

standards, the maximum LQA score (assigned for receiving an

optimum sounding is 70%), and the minimum score is 30%. The

score given to a station that did not send any sounding or a station

whose sounding has not been received is also 30%.

• QCAL

Quick Call: enable/disable initiating a call to the last called address by

pressing the MIC PTT button twice in rapid sequence (double

pressing).

• AADR

Automatic address: enable/disable automatically adding the source

addresses of incoming calls to the ALE directory.

Note

If the directory is full, new addresses will not be

added.

_________________________________________________________________________________________________

1 2 ... 68 69 70 71 72 73 74 75 76

Commentaires sur ces manuels

Pas de commentaire

Motorola MICOM-2TS Spécifications Page 73

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Motorola MICOM-2TS