Motorola MICOM-2TS Spécifications Page 106
- Page / 132
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
67
Installation
General
This section describes the installation of the radio in a mobile or fixed
station configuration.
The following paragraphs contain general installation procedures for
both types of configuration.
Government Regulations
Read carefully the Licensing and Safety Information given in the front
matter of this manual. Be sure that all your radio operation complies
with these guidelines.
Inspection
Carefully inspect the radio immediately upon receipt, and notify the
shipper of any damage incurred in transit.
Radio Installation Planning
Select the mounting location for convenience of access to electrical
connections and for maintenance. The selected location should be
clean, dry and well ventilated. Do not mount the unit in close proximity
to strong electrical fields produced by brush motors and generators,
welders, etc.
The antenna, antenna tuner and associated cable kits are provided
separately. These should be installed before the radio is installed.
Follow the instructions included with the units and kits.
The radio may be placed on any sturdy, flat surface. An accessory
mounting tray (included in the Mobile Mounting Kit, FLN2272) allows the
radio to be mounted in any position.
Before installing the radio, read the entire installation procedure detailed
in this section. Follow the instructions carefully.
No preliminary internal wiring connections are required before installing
the radio.
- MICOM-2E ALE 1
- COMPUTER SOFTWARE COPYRIGHTS 2
- Table of Contents 6
- MICOM-2E ALE Owner’s Manual 7
- Contents 8
- Glossary 10
- Transmit 12
- FCC Information 13
- Transmitter 14
- Receiver 15
- Technical Specifications 16
- Blasting Caps and Areas 19
- Guidelines and Warnings 20
- Vehicles With an Air Bag 21
- Restrictions 22
- Introduction 24
- Transmitter Features 25
- Receiver Features 26
- Frequency Sources 26
- Power Source 26
- CW Keying Operation 26
- Programmable Features 27
- Overview 28
- LED Indicators 29
- Icon Indicators 31
- Transceiver Rear Panel 32
- Alert Tone Indications 32
- Operating Instructions 34
- Global Operations 35
- Using Working Modes 36
- Choosing a New Channel 38
- Simplex Frequency (SMPX) 42
- Duplex Frequency (DPLX) 42
- Working in Scan Mode 43
- To enter Scan mode: 43
- Working in BITE Mode 44
- To enter BITE mode: 44
- Working in Lock Mode 45
- To enter Lock mode: 45
- Working in Program Mode 46
- To enter Program mode: 46
- Setting a Password 47
- Changing a Password 48
- Working in Transmit Mode 49
- To transmit: 49
- Checking the RF Power 49
- Working in DIM Mode 50
- To enter DIM mode: 50
- Programming the Radio 52
- Programming Channels 53
- Choosing the Band Type 58
- • USB - upper side band 58
- • LSB - lower side band 58
- To set the channel band: 58
- To set the AGC speed: 60
- Setting Radio Parameters 62
- Microphone Side Tone (MST) 64
- Accessory Side Tone (AST) 64
- PTT Release Beep (PTBP) 64
- Keyboard Beep (KBBP) 65
- To set the time-out time: 66
- Setting Radio Options 67
- To disable ALE: 85
- LQA Memory 87
- Automatic Sounding 87
- Figure 1: Network Occupancy 88
- Immediate (Manual) Sounding 89
- Bi-directional Handshake 90
- ALE Programming 90
- Receiving Calls 91
- Receiving an Individual Call 92
- Receiving a Net Call 93
- Receiving a Sound Call 94
- Transmitting Calls 95
- To send an AllCall: 96
- Transmitting Individual Calls 97
- To make an individual call: 97
- Transmitting Net Calls 99
- To make a net call: 99
- (see page 13). Press 101
- to view the parameters 101
- Using the Caller Stack 102
- Monitoring the Speaker 104
- Tuning the Antenna Tuner 105
- Installation 106
- Figure 2: Power Supply 107
- Front Model Installation 108
- Trunk Model Installation 110
- Step 1 112
- Step 2 112
- Step 3 112
- Step 4 113
- Step 5 113
- Figure 10: Microphone Clip 115
- External Speaker Installation 116
- Connectors 118
- * Do not connect to GND 119
- DC Connector J4 120
- Vehicular Noise Reduction 121
- Maintenance 122
- Table 4. Error Messages 123
- Troubleshooting 124
- Table 6. Failure Messages 125
- Radio Checks 127
- Procedures 128
- MICOM-2E-ALE Owner’s Manual 131
- @68O2952C60@ 132
Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Motorola MICOM-2TS
(56 pages)© 2020, manymanuals.fr. Tous droits réservés | 1.524 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels