Motorola MICOM-2TS Spécifications Page 21
- Page / 132
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
MICOM-2E-ALE Owner’s Manual
xvi
It is mandatory that radio installation in vehicles fueled by
liquefied petroleum gas conform to the following standard:
National Fire Protection Association standard NFPA 58 applies to radio
installations in vehicles fueled by liquefied petroleum (LP) gas with LP
gas container in the trunk or other sealed-off space within the interior of
the vehicles. The standard requires that:
1. Any space containing radio equipment shall be isolated by a seal
from the space in which the LP-gas container and its fittings are
located.
2. Remote (outside) fitting connections shall be used.
3. The container space shall be vented to the outside.
Vehicles With an Air Bag
An air bag inflates with great force. Do not place objects,
including portable or mobile two-way radios, in the area over
the air bag or in the air bag deployment area. If improperly
installed or placed wireless equipment is in the air bag
deployment area and the air bag inflates, serious injury could
result.
Installation of the MICOM-2E radio should be performed by a
professional installer/technician qualified in the requirements for such
installations. An air bag’s size, shape and deployment area can vary by
vehicle make, model and front compartment configuration (e.g., bench
seat vs. bucket seat).
Contact the vehicle manufacturer’s corporate headquarters, if
necessary, for specific air bag information for the vehicle make, model
and front compartment configuration involved in your communication
equipment installation.
- MICOM-2E ALE 1
- COMPUTER SOFTWARE COPYRIGHTS 2
- Table of Contents 6
- MICOM-2E ALE Owner’s Manual 7
- Contents 8
- Glossary 10
- Transmit 12
- FCC Information 13
- Transmitter 14
- Receiver 15
- Technical Specifications 16
- Blasting Caps and Areas 19
- Guidelines and Warnings 20
- Vehicles With an Air Bag 21
- Restrictions 22
- Introduction 24
- Transmitter Features 25
- Receiver Features 26
- Frequency Sources 26
- Power Source 26
- CW Keying Operation 26
- Programmable Features 27
- Overview 28
- LED Indicators 29
- Icon Indicators 31
- Transceiver Rear Panel 32
- Alert Tone Indications 32
- Operating Instructions 34
- Global Operations 35
- Using Working Modes 36
- Choosing a New Channel 38
- Simplex Frequency (SMPX) 42
- Duplex Frequency (DPLX) 42
- Working in Scan Mode 43
- To enter Scan mode: 43
- Working in BITE Mode 44
- To enter BITE mode: 44
- Working in Lock Mode 45
- To enter Lock mode: 45
- Working in Program Mode 46
- To enter Program mode: 46
- Setting a Password 47
- Changing a Password 48
- Working in Transmit Mode 49
- To transmit: 49
- Checking the RF Power 49
- Working in DIM Mode 50
- To enter DIM mode: 50
- Programming the Radio 52
- Programming Channels 53
- Choosing the Band Type 58
- • USB - upper side band 58
- • LSB - lower side band 58
- To set the channel band: 58
- To set the AGC speed: 60
- Setting Radio Parameters 62
- Microphone Side Tone (MST) 64
- Accessory Side Tone (AST) 64
- PTT Release Beep (PTBP) 64
- Keyboard Beep (KBBP) 65
- To set the time-out time: 66
- Setting Radio Options 67
- To disable ALE: 85
- LQA Memory 87
- Automatic Sounding 87
- Figure 1: Network Occupancy 88
- Immediate (Manual) Sounding 89
- Bi-directional Handshake 90
- ALE Programming 90
- Receiving Calls 91
- Receiving an Individual Call 92
- Receiving a Net Call 93
- Receiving a Sound Call 94
- Transmitting Calls 95
- To send an AllCall: 96
- Transmitting Individual Calls 97
- To make an individual call: 97
- Transmitting Net Calls 99
- To make a net call: 99
- (see page 13). Press 101
- to view the parameters 101
- Using the Caller Stack 102
- Monitoring the Speaker 104
- Tuning the Antenna Tuner 105
- Installation 106
- Figure 2: Power Supply 107
- Front Model Installation 108
- Trunk Model Installation 110
- Step 1 112
- Step 2 112
- Step 3 112
- Step 4 113
- Step 5 113
- Figure 10: Microphone Clip 115
- External Speaker Installation 116
- Connectors 118
- * Do not connect to GND 119
- DC Connector J4 120
- Vehicular Noise Reduction 121
- Maintenance 122
- Table 4. Error Messages 123
- Troubleshooting 124
- Table 6. Failure Messages 125
- Radio Checks 127
- Procedures 128
- MICOM-2E-ALE Owner’s Manual 131
- @68O2952C60@ 132
Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Motorola MICOM-2TS
(56 pages)© 2020, manymanuals.fr. Tous droits réservés | 1.313 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels