Motorola MTM5400 Guide de l'utilisateur Page 49

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 176
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 48
42
TMO Group Call
The terminal sounds a tone as explained in the note below.
To block reception of a Group Call, select Optns then
Block. Powering off/on the terminal unblocks the reception
of this Group Call.
Receiving a Group Call during an On-going Group Call
Depending on how the Service Provider has configured
incoming calls, the incoming call will either be:
Forced upon you and will interrupt the on-going call (if the
incoming call has higher priority than the on-going call).
OR
Presented to you (if it has higher
priority than the on-going call).
To accept the call, press
Join.
To cancel the call, press End.
Receiving an Emergency Group Call
For detailed information, see page 29.
Receiving a Broadcast Call
For detailed information, see page 30.
Transmit Inhibit
You can activate the Transmit Inhibit (TXI) Mode before
entering RF sensitive areas, e.g. in hospitals or in potentially
explosive areas, where safety can be jeopardized due to
MTM5400 transmission radiation.
When receiving a High Priority Group Call, you will hear a
“High Priority Group Call” tone (if configured by your Service
Provider).
When receiving a Group Call from your scan list, which is not
from a high priority group, you will hear a “New Group Call”
tone (if configured by your Service Provider).
Radiation of the MTM5400 is only suppressed if the TXI Mode is
activated or the MTM5400 is separated from power supply.
Group In Use
ID:David
TG4
End
Join
Vue de la page 48
1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 175 176

Commentaires sur ces manuels

Pas de commentaire