Motorola MTM5400 Guide de l'utilisateur Page 75

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 176
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 74
68
Emergency Operation
An Emergency Group Call is configured as non-tactical or
tactical:
A non-tactical call initiates on a talkgroup designated by
your Service Provider. The group might be different than
the one displayed on the terminal screen when starting the
call.
After exiting from non-tactical emergency mode the
terminal will be attached to the group that was selected
before initiating the non-tactical call. When in non-tactical
emergency mode, you will not be able to switch
talkgroups.
DGNA messages have no impact during non-tactical
emergency mode but only after exiting the non-tactical
emergency mode.
A tactical call initiates on the currently selected talkgroup.
Emergency Call
You are able to make an Emergency Call either by PTT
(when in Emergency Mode) or emergency button/footswitch,
if it is enabled. Terminal provides the information about the
current active Emergency Call. If the Emergency Calls are
disabled you are going to see PTT Denied on the screen.
Emergency Power Up during PIN Lock
Terminal enters Emergency Mode without PIN Lock
prompted no matter if in service or not. When you exit the
Emergency mode, the terminal will go back to the PIN Lock
entry screen.
Alarm Addressing
Address type is Private, message is sent to predefined
individual address.
Address type is Group:
Tactical - message send to attached talkgroup
Non-Tactical - message send to predefined group defined
in GSSI/ISSI
Vue de la page 74
1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 175 176

Commentaires sur ces manuels

Pas de commentaire