Motorola STARLINE SERIES Manuel d'utilisateur Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 6
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
Motorola, Inc.
101 Tournament Drive
Horsham, PA 19044
www.motorola.com/broadband
04.03.07
Rev 9
MOTOROLA, the Stylized M Logo, STARLINE, and LIFELINE are registered in the US Patent & Trademark Office.
All other product or service names are the property of their respective owners.
©
Motorola, Inc. 2006. All rights reserved.
Specifications are subject to change without notice.
4
Specification Notes:
1. Operating passband of station. Diplex filters are plugged into the electronic chassis.
2. Referenced to the average gain across the stated passband.
3. Minimum full gain at 1003 MHz includes loss of equalizer but Bode slope reserves have not been set. Return gain includes loss of SRE-*-4 return equalizer.
4. Operational gain includes loss of slope reserves as well as equalizer.
5. Amount of Bode slope control range from midpoint (typical setting is -4 dB at 1003 MHz @ 20°C). This control should not be used for gain reduction.
6. Amount of slope created and cable equivalence of fixed interstage equalizer. Interstage equalizer is a plug-in.
7. Noise Figure is specified at room temperature at the cable entry facility of the housing and includes the loss of 1 dB for the pre-stage equalizer. The return Noise Figure includes the station loss
preceding the RF hybrid. The noise figure from Fmin to 870 MHz over temperature is 8.5 dB worst-case and from Fmin to 1003 MHz is 9 dB worst-case.
8. Frequencies that relate the picture carriers or passband edges to the specified output levels and tilts.
9. Measured with CW carriers and spectrum analyzer over specified temperature range. References the worst-case channel. Specifications are compliant with the test methods as stated in NCTA
RECOMMENDED PRACTICES FOR MEASUREMENTS ON CABLE TELEVISION SYSTEMS.
10. Measured with wave analyzer and synchronous, 100% depth modulated channels. References the worst-case channels over specified temperature range. Specifications are compliant with the
test methods as stated in NCTA RECOMMENDED PRACTICES FOR MEASUREMENTS ON CABLE TELEVISION SYSTEMS.
11. Composite Second Order distortion refers only to those beat clusters that fall +0.75 MHz and +1.25 MHz above the subject picture carrier. CSO beat clusters that have a -0.75 MHz and -1.25
MHz relationship to the subject picture carrier are not included in this specification.
12. Test points should be used with GFAL adaptor.
13. Match measurement at the station input and output, cable-entry facilities, at the specified passbands for operational gain.
14. Measured with the stated AC Bypass Current.
15. Measured at the power connector.
16. Current draw at +24.0 VDC.
17. AC current is stated in RMS continuous. A 10-amp compatible electronics package is also available for installing into older 10-amp housings during upgrades.
18. Group Delay is specified for standard NTSC video, where delay is the delta from picture carrier to 3.58 MHz color subcarrier. Reverse delay is in a 1.5 MHz bandwidth.
19. Distortion numbers are worst case over temperature in a cascade.
20. The compressed data loading is QAM carriers and are –6 dB relative to the analog CW carriers.
21. CTB (Composite Triple Beat). At the specified channel loading, Enhanced Gallium Arsenide performance varies on a two point three-for-one (2.3:1) basis with amplifier output level.
Input
port
Output
port
**
**
** ** **
H
L
SFE
JXP-B
**
SRE
-16 dB
JXP-B
LPF
BODE
RC
**
Therm
PP
PD
TP
-20 dB
TP
-20 dB
** **
**
**
ICS
JXP
JXP-B
**
Manual
**
**
LDR
H
L
Auto
TP
-20 dB
24 Vdc
DC test point
Power
supply
Fuse
Power
Block
Jumper
** Plug-in module
FTEC
Surge
protector
Surge
protector
**
Status
monitor
ADU/
TDU
SCS
-1.0dB
-1.0dB
-1.0dB
28 dB
-6.5dB
-1.0dB
-1.0dB
-1.0dB
-0.5dB
+30.0dB
-0.3dB
-0.4dB
-0.4dB
-0.4dB
RF
RF/
AC
AC
-1.7 dB F
-1.0 dB R
RF/
AC
AC
RF
-1.7 dB F
-1.0 dB R
23 dB
TP
Return
injection point
-20 dB
OnBrd
Atten
OnBrd
Atten
~ -3 dB
BLE100 Block Diagram
Vue de la page 3
1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire