Motorola LS1000B Spécifications télécharger pdf (Page 44)

4-8

LS 1004 Product Reference Guide

enabled. To do this, scan the DECODE UPC ONLY ENABLE bar code. You’ll hear hi/lo/hi/

low warble. The warble sound indicates that the scanner has been successfully programmed

for the selected parameter. Other beeper indications are listed in Chapter 3.

The default for INTERCHARACTER DELAY is 0 msec, but you need it set to 2 msec. To

program the scanner for a 2msec intercharacter delay, scan the bar codes listed below. This

sequence includes a two-digit entry; single-digit entries require a leading zero.

You’ll hear...

1. Scan INTERCHARACTER DELAY Short high tone

2. Scan 0 Short high tone

3. Scan 2 Hi/Lo/Hi/Lo warble

Errors While Scanning

Don’t worry if you make an error during a scanning sequence. If you’re scanning a multi-step

sequence, scanning CANCEL removes you from that sequence so that you can start again.

Otherwise, simply scan the single correct bar code for the desired parameter.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 95 96

Pas de commentaire

Motorola LS1000B Spécifications Page 44