Motorola VIP1700 Manuel d'utilisateur télécharger pdf (Page 6)

Note: The selection should match the type of cable you are using, i.e. if using a S-Video

cable the S-Video selection should be ON.

Note: In addition to RGB, it’s also possible to get S-Video or Composite video from

the SCART connector. In this case a special SCART to SVideo or SCART to composite

cable is required.

5. When the correct video signal is selected, the TV-image should be stable without ﬂicker

or disturbances.

6. Color system Use the Left and Right main cursor buttons to toggle between PAL and

NTSC. (Remote control is displayed in the picture 1.3.)

7. When the Color system and Video output are set, it is possible to use:

• OK button - to leave the dialog and save all changes made

• STOP button - to leave the dialog without saving any changes

8. After saving the changes, the Kreatel IP-STB will be rebooted. The following dialog will

be shown for two seconds regardless if any changes have been made or not:

Figure 1.2: Kreatel STB – Rebooting from Setup

1.4 Kreatel IP-STB boot progress indicators

During the booting process, the Kreatel IP-STB displays a number of coloured dots on the

screen. These may be used for error handling. Five dots are available, and each of these may

either be dark grey, steady red, steady yellow, blinking yellow or steady green. The dark grey

colour is used to represent an inactive state. Colors meaning are described in table 1.1.

1.5 Portal control – Remote control

Picture of the remote control, which is enclosed for STB VIP1500 and VIP1700 manufactured

by Motorola, is displayed in the following picture together with the information about the basic

control elements:

DocID: STBGUIDE Page: 3 / 26

Security level: public Revision: 40127 /bobek

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Motorola VIP1700 Manuel d'utilisateur Page 6