Motorola SBV5220 Manuel d'utilisateur télécharger pdf (Page 14)

Introduction Installation Troubleshooting Glossary License

SBV5220 VoIP Cable Modem User Guide 5

Before You Begin

Before you begin the installation, check that you received the following items with your VoIP cable modem:

You will need 75-ohm coaxial cable with F-type connectors to connect your VoIP cable modem to the nearest

cable outlet. If a TV is connected to the cable outlet, you may need a 5–900 MHz RF splitter and a total of three

coaxial cables to connect both the TV and the VoIP cable modem. The coaxial cable and RF splitter are available

at consumer electronics stores. To connect your VoIP cable modem to an Ethernet hub, see the network

description in “Cabling for Multiple Users” on page 35. Check the documentation provided with your hub.

Caution

Item Description

Power

adapter or

cable

Connects to the AC power outlet

10/100Base-T

Ethernet

cable

Connects to the Ethernet port

USB cable Connects to the USB port

Phone wire Connects the telephone to the cable system to provide telephone service

SBV5220

VoIP Cable

Modem

CD-ROM

Contains the User Guide and USB drivers

Battery Provides standby power for your SBV5220 (one each). The SBV5220 has

the capability to accommodate two standby batteries. For additional standby

batteries, contact your service provider.

This product is for indoor use only. Do not route the USB, Ethernet, or telephone cables outside of the

building. Exposure of the cables to lightning could create a safety hazard and damage the product.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 63 64

Pas de commentaire

Motorola SBV5220 Manuel d'utilisateur Page 14