Motorola WE800G Manuel d'utilisateur télécharger pdf (Page 37)

SECTION 2 INSTALLATION

2-20 SECTION 2, INSTALLATION

After you have logged in, for security reasons, you should change the User ID

and Password. See Wireless Security Setup.

4 Click the LOG IN button to enter the Wireless Ethernet Bridge’s

Web-based Configuration Utility.

Wireless Security Setup

Follow these procedures to setup the correct security protocols for

your Wireless Ethernet Bridge.

1 Select Control Panel > Device Security.

2 In the Login User ID field, enter in the desired USER ID. For

strong security, select an ID that contains a multiple of

case-sensitive characters as well as numbers. It cannot be longer

than 64 bytes.

3 In the Login Password field, enter in the desired PASSWORD.

For strong security, select an ID that contains multiple of

case-sensitive characters as well as numbers and symbols like

“_ + )”. It cannot be longer than 64 bytes.

4 In the Password Confirm field, re-enter the same PASSWORD.

5 Click APPLY.

6 Once the settings have been accepted, click RESTART and log

back into the Configuration Utility using your new User ID and

Password.

7 Select a Profile and navigate to the Basic tab.

8 Enter the Network ID (SSID) to match the SSID of the network

and click APPLY. Or, if using in Ad-Hoc mode, enter a user

friendly SSID, which will be used by your client adapter.

9 Navigate to Security.

10 Select Pre-Shared Key (PSK) from the drop down list of ESS

Auth Mode.

11 Select WEP128 from the drop down list of Encryption Status.

12 Click APPLY and click RESTART again. Your wireless

configuration is now complete for the selected Profile.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 70 71

Pas de commentaire

Motorola WE800G Manuel d'utilisateur Page 37