Motorola DSP56800 Guide de l'utilisateur télécharger pdf (Page 229)

100

101

Debugging for DSP56800E

Command-Line Debugging

229Targeting MC56F83xx/DSP5685x Controllers

NOTE There is no synchronization of debug events in the startup script.

Consequently, add the run debugging command to the startup script

and place the following debugging commands in another script to

execute them: debug, go, stop, kill, next, and step.

Command-Line Debugging Tasks

This section describes some tasks for command-line debugging.

Open a Command-Line Debugging Window

To open a command-line debugging window, choose Debug > Command Line

Debugger.

When the debugging window opens, it displays several command hints at the bottom

of the window.

Enter a Single Command-Line Debugging Command

To enter a single debugging command:

1. Type a command (or its shortcut followed by a space) on the command line.

(For example, the shortcut for the break command is b.)

2. If needed, type any options, separating them from the command and each other

with spaces.

3. Press Enter.

Enter Multiple Command-Line Debugging Commands

To enter multiple debugging commands:

1. Decide which commands (Tcl and debugger-specific) to use.

2. Type the commands into a file.

3. Save the file with a .tcl extension to indicate that it is a Tcl script.

4. Enter the run command to run the script.

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 445 446

Commentaires sur ces manuels

Pas de commentaire

Motorola DSP56800 Guide de l'utilisateur Page 229

Commentaires sur ces manuels

Produits connexes et manuels pour Processeurs Motorola DSP56800