Motorola MTM5400 Manuel d'installation télécharger pdf (Page 33)

INSTALLATION MTM5400 Mobile Terminal Installation Manual 33

Installation Procedure

1. Select either the transmission hump or an open underneath portion of the dash to mount your

terminal (see

Figure 6). When mounting the trunnion on the transmission hump, be careful

that the transmission housing is not affected.

2. Use the trunnion mounting bracket as a template, to mark the hole positions on the mounting

surface. Use the innermost three holes for a curved mounting surface, such as the

transmission hump, and the three outermost holes for a flat surface such as under the dash.

3. Centre-punch the spots you marked and use a 4 mm (5/32-inch) bit to drill a hole at each

location.

4. Secure the trunnion mounting bracket to the mounting surface with the three self-tapping

screws provided. (See

Figure 6.)

5. Slide the terminal into the trunnion. Secure the terminal with the two wing screws provided.

6. Ground the radio housing to the nearest vehicle chassis ground point, which can be done by

removing the paint from the trunnion where the radio and vehicle chassis touches the

trunnion, or use a short cable with ring lugs in both end and connect this to chassis under

wingscrew.

The keypad labelling of the control head may vary

according to the specific customer/country concerns.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 79 80

Pas de commentaire

Motorola MTM5400 Manuel d'installation Page 33